8' x 5' Tandem Axle Trailer: Springs

8-x-5-Tandem-Suspension.png

Spring Setup

Divide the chassis length in half and mark the chassis rails, then accurately measure where you want the spring centres to be - ideally 50mm back from the centre of the chassis. Double check your measurements.

Spring-Setup.png

Set up your suspension rocker so the main rocker bolt centre is lined up with the suspension offset you have marked and clamp in position. Set up the front spring in its hanger and fit to the rocker unit. Adjust the spring so that the tail of the spring can move freely when the rocker oscillates without binding or dropping out.

Tandem-spring-7.png

Bolt the rear spring into the rocker unit

Tandem-spring-4.png

Make sure that the outside spring edges are flush with the outside edge of the chassis rail and once double checked, tack weld the spring hanger and suspension rocker to the chassis rail.

Once this is completed on both sides, position the slippers over the spring tails allowing for clearance between the spring and the slipper for the spring to move in and out when loaded.

8-x-5-Tandem-Click-to-Buy.png

Again make sure the outside edge of the spring is flush with the outside edge of the chassis and tack weld the slipper in place.

Where the spring components are unsupported fully along the chassis rails, you will need to cut a couple of packers to support the overhang of these parts and weld into position.

Tandem-spring-6.png

Once all components are in position, remove the springs and fully weld around the hanger, rocker, slipper and packers.

Next it is time to measure up our axle - Click AXLE below